Home > Products > ELECTRONICS & ELECTRICITY TRAINING SYSTEM > Digital & Analog Electronics Trainers (Components Experiments)

Digital & Analog Electronics Trainers (Components Experiments) DAT-6000 Downloadable Data Sheet     OVERVIEW   The DAT-6000 is a full functional digital ad analog electronics training system that meets the needs of most R&D labs and digital ad analog electronics training programs, all compoenents and accessories provided to complete the digital and analog electronics experiments.   EXPERIMENTS COVER   The DAT-6000 come with main unit ULT-3000, compoenets, acessories and experiments manual to cover the following experiments topics :   (A) Digital Electronics Experiments Lists Cover In the Lab Manual :   Fundamental Logic Gate – AND, OR, NOT Fundamental Logic Gate – NAND, NOR, XOR Application Of Boolean Algebra De Morgan’s Law (I) De Morgan’s Law (II) Diode Resistor Logic – AND Exclusive OR Using Basic Logic Gate Exclusive NOR Using Basic Logic Gate Demultiplexer – Using The 74138 IC Synchronous Up – Counter Synchronous Down – Counter The Schmitt Trigger Oscillator – Using CMOS  (B) Analog Electronics Experiments Lists Cover In the Lab Manual :   The Superposition Theorem Capacitors in Voltage – Divider Networks Operational Amplifier – The Inverting Amplifier Operational Amplifier – The Non Inverting Amplifier Operational Amplifier – The Comparator Operational Amplifier -  The Summing Amplifier The Common – Base Amplifier Structure The Common – Emitter Amplifier Structure The Common – Collector Amplifier Structure The Op Amp Differentiator The Op Amp Integrator The RC Phase Shift Oscillator The Schmitt Trigger The Astable Multivibrator The D/A Converter The A/D Converter  SPECIFICATIONS (MAIN UNIT : ULT-3000)   1.     DC Power Supplies Module Fixed Output : +5V/1A, -5V/0.5A, +12V/0.5A, -12V/0.5A Variable Output : +0V to +24V/1A, -0V to -24V/1A All power supplies are short circuit protected   2.     AC Power Supplies Module 19V–15V–9V–0V–9V–15V-19V   3.    Function Generator (2 Channels) & Clock Generator (2 Channels) Sine, Triangle and Square waveform output Frequency range : 1Hz to 1MHz in 6 decades With fine adjust, Amplitude and DC offset control Clock output 1Hz to 1MHz in 6 decades Six frequency ranges: 1Hz to 10Hz 10Hz to 100Hz 100Hz to 1KHz 1KHz to 10KHz 10KHz to 100KHz 100KHz to 1MHz Sine wave output: 0 to 20V peak to peak variable Triangle wave output: 0 to 15V peak to peak variable Square wave output: 0 to 22V peak to peak variable   4.     Breadboard Module        with 1685 tie points   5.     TTL/CMOS Selection Switch        Select TTL or CMOS Mode for data switches ONLY   6.     2-Single Shot Pulse Output Module           80uS Pulse (Negative & Position)   7.     Two digits of 7-segment LED Display Module   8.     8-bit LED Indicators with buffer Module   9.     8 HI/LO Data Output Switches Module   10.   3-State Logic Probe Module        with 7-segment display   11.   Speaker Module        8 Ohm, 0.25W With Buffer   12.   Digital DC Volt Meter         4 Digits LED display          Four voltage ranges :              0V to 199.9VDC                                              0V to 19.99VDC              0V to 1.999VDC                                0V to 199.9mVDC          Input Impedance: 10Mohm for any range   13.   Potentiometer Module With 10K, 50K and 100K Ohm Potentiometers   14.   Adaptors Interface Module        2mm & 4mm Adaptor Interface Socket to turn pins   15.   BAR Graph Module 10 BAR display (1V perBAR up   The ULT-3000 is shipped with a comprehensive Instruction Manual and a power cord.   Power Supply : 240VAC, 50Hz (Fused Protected) Dimensions : (W x D x H) 310 x 260 x 90mm Weight : 3.5 kgs